Bench tuning is quite easy and often times the ECU can be programmed over the OBD socket but is frequently removed due to other reasons. Most times,it is often difficult to access the complete map data region over the OBD socket, this signifies the failure of the ECU which requires replacement. For our Bench ECU tuning, we offer bench tuning services which requires that our customers have to remove their modules and send them over to us. If needed we also offer our bench tuning services at our shop or onsite.
Quite a number of later vehicles have installed in them the anti-tune software programming which relates to the fact that such vehicles are unable to be remapped via the OBD socket. Most of our competitors are only able to provide OBD remapping but definitely not here at VEPro. We usually advice an oil and filter map change before the remap if your vehicle is yet to have undergone servicing in recent times. This makes sure that you get optimal results from the remap and your engine stays in a healthy state as much as possible.
For ages now, car engines have been controlled electronically by the use of an ECU (Electronically controlled unit). This constitutes the brain of the vehicle and defines the timing of the ignition, boost pressure, fueling and other parameters required for running an efficient car engine. These parameters can be fully optimized to improve the welfare and performance of your car engine. This is achieved by reprogramming the factory ECU within your car. A bench ECU remap causes most of the following: